Dongguan Zhicheng Machinery Co., LTD
Dongguan Zhicheng Machinery Co., LTD

2021

06-16

Quilting Embroidery Machine small class explanation: the principle of embroidery machine machinery and electrical appliances?

First use embroidery CAD software to make a pattern, and after generating a pattern, put the disks containing the embroidery program and patterns into the computer disk drive respectively.

View details

2021

06-30

Quilting Embroidery Machine tells: computer-based embroidery machine related knowledge!

According to the number of heads, it can be divided into single head and multi head (2-24 heads).

View details

2021

07-07

Quilting Embroidery Machine small class explanation: the details you need to know to use the embroidery machine!

The embroidery machine with a good thread trimming, when the needle is cut after the thread is trimmed, usually two to three stitches slowly can bring the upper thread with the bottom thread, and the thread will not drop. It takes about five stitches to bring up the upper thread in a bad machine with a slow stitch step. If the slow stitch step is too long, it will affect the efficiency, and there will also be obvious problems with the lower stitch point.

View details

2021

07-21

Classification of digital control quilting and embroidery machine

This article introduces the classification of digital control quilting and embroidery machine

View details

2021

07-27

Digital control quilting and embroidery machine small class explanation: How to clean the floppy drive head of the embroidery machine!

Drop 2-5 drops of cleaning fluid on both sides of the reading and writing holes of the cleaning disk. The amount of cleaning fluid should be moderate. Too little amount will not clean the surface of the head. If you use too much, it will leave cleaning on the surface when cleaning the head. Liquid affects the life of the magnetic head. Sometimes it will cause short circuit of electronic circuit and burn out components.

View details

2021

08-03

Digital control quilting and embroidery machine small class explanation: How to use the computerized embroidery machine?

Enter the data into the machine, adjust the approximate starting position, and go empty first to determine whether the position setting is appropriate. If appropriate, go back to the original point directly, exit the idling, and click "Direct Embroidery" to start.

View details
< 1...222324...33 > proceed page