When embroidery first broke away from manual embroidery, the so-called embroidery machine at that time was actually not an embroidery machine in the sense, because at that time, a traditional sewing machine was replaced with a bottom plate with a small round hole, and the needles of the sewing machine kept going in and out. Coupled with the hand-held embroidery frame and the back and forth movement, in fact, this so-called embroidery machine is still a kind of hand embroidery. When using the embroidery machine, thread breakage often occurs. This may be because a certain part of the embroidery machine has malfunctioned. At this time, in order to ensure that the accuracy and quality of the trimming work will not be delayed, the machine needs to be shut down for maintenance. Today, the editor of Quilting Embroidery Machine (double width) will give a brief introduction.
If the thread breaks during the operation, you need to check whether each head of the embroidery machine has the same situation. If so, you can consider whether the transmission belt is loose, and check whether the frame belt is loose. Whether the feet are loose, for these loose situations, you need to adjust and tighten them in time.
Sometimes the rotation speed adjustment bed of the embroidery machine is out of oil, the stitch adjustment is too small, or even the machine cannot complete the embroidery work well. At this time, you need to check whether the rotation speed adjustment bed is indeed there and add a proper amount of lubrication. And adjust the size of the stitches.
In the embroidering process, the machine head is also prone to failure. When the machine head fails, you need to change the needle and check whether the presser foot is notched and fluffy. The distance between the needle tip and the presser foot is 0.3cm.
Check whether the distance between the bur and the needle plate is normal. If the two are too close, the needle plate is easy to fluff. At this time, it is necessary to pull the coarse sand into a 1cm strip, and then sand the fluffed part after putting it in. smooth. Check whether there are nicks or lint on the surface of the shuttle bed. If there are nicks or lint, you can use fine sand skin to polish it.
After using for a long time, the spinner rod is prone to shake left and right. This is a normal situation, but if the spinner shakes back and forth, you need to adjust it.
The above is the editor of Quilting Embroidery Machine (double width) introducing its maintenance knowledge, I hope it can help you.